P1696

P1696 - EEPROM Memory Write Denied, Invalid






For wiring diagrams, refer to.

• When Monitored: With the ignition on.

• Set Condition: An attempt to program or write to the internal EEPROM failed. Also checked at power down. One trip fault. Three good trips to turn off the MIL.






• Always perform the pre-diagnostic troubleshooting procedure before proceeding. Refer to => Non-DTC Based Diagnostics. Pre-Diagnostic Troubleshooting Procedure

Test Step 1 - DTC is Active

• Diagnose and repair any other DTCs set in the PCM before proceeding with this test.

• Turn the ignition ON.

• With the scan tool, clear DTCs.

• Start the engine and allow it to reach operating temperature.


When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.

• It may be necessary to test drive the vehicle in order for this DTC to set.

• With the scan tool, select view DTCs.

Is the status active for this DTC?

Yes

• Go to Test Step 2 => [ Test
Step 2 - PCM Odometer Mileage Not Programmed ]

No

• Refer to the checking for an intermittent DTC diagnostic procedure. Refer to => Non-DTC Based Diagnostics. Checking for an Intermittent DTC

Test Step 2 - PCM Odometer Mileage Not Programmed

• Turn the ignition ON.

• With the scan tool, attempt to perform the program PCM odometer function.

• With the scan tool, clear DTCs.

• Start the engine.

• Allow the engine to reach normal operating temperature.

• With a scan tool, select view DTCs.

Is the status active for this DTC?

Yes

• Go to Test Step 3 => [ Test
Step 3 - Checking the PCM Power and Ground Circuits ]

No

• The SRI mileage has been successfully programmed into the PCM. Test is complete.

• Perform the PCM Verification Test. Refer to => Non-DTC
Based Diagnostics. PCM Verification Test

Test Step 3 - Checking the PCM Power and Ground Circuits

• Perform the diagnostic procedure for Checking the PCM Power and Ground Circuits. Refer to => Non-DTC Based Diagnostics. PCM Power and Ground Circuit Test

Were any problems found?

Yes

• Repair as necessary.

• Perform the PCM Verification Test. Refer to => Non-DTC
Based Diagnostics. PCM Verification Test

No

• Go to Test Step 4 => [ Test
Step 4 - PCM ]

Test Step 4 - PCM

• Turn the ignition ON.

• With the scan tool, attempt to perform the program PCM odometer function.

• With the scan tool, clear DTCs.

• Start the engine.

• Allow the engine to reach normal operating temperature.

• With a scan tool, select view DTCs.

Is the status active for this DTC?

Yes

• Replace and program the PCM.

• Perform the PCM Verification Test. Refer to => Non-DTC
Based Diagnostics. PCM Verification Test

No

• The SRI mileage has been successfully programmed into the PCM. Test is complete.

• Perform the PCM Verification Test. Refer to => Non-DTC
Based Diagnostics. PCM Verification Test