Memory Seat Module
U0014-00-CAN Interior Bus (+) Circuit High
For a complete wiring diagram, refer to.
• When Monitored: Continuously when the ignition is on. The battery voltage between 10 volts and 16 volts. Ignition Off Draw (IOD) fuse installed. Totally Integrated Power Module (TIPM) is configured correctly.
• Set Condition: A short to voltage is detected on the CAN Interior Bus (125K) (+) circuit.
Test Step 1 - VERIFY DTC IS ACTIVE
• Make sure the IOD fuse is installed and the battery is fully charged before proceeding.
• Turn the ignition on.
• With the scan tool, read active DTCs.
Is this DTC active?
Yes
• Refer to => Electrical System DTC Based Diagnostics and perform the diagnostic test procedure for DTC U0010-CAN INTERIOR BUS. U0010
No
• Refer to => Non-DTC Based Diagnostics and perform the Stored Lost Communication DTCs diagnostic procedure. Stored Lost Communication DTCs