Blind Spot Module

U0141 - Lost Communication with LPM

For a complete wiring diagram, refer to.

• When Monitored: Continuously when the ignition is on. battery voltage between 10 and 16 volts. IOD fuse installed. TIPM is configured correctly.

• Set Condition: Bus messages not received from the TIPM for approximately 2 to 5 seconds.






Test Step 1 - Verify Diagnostic Trouble Code Is Active

• Ensure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

• With the scan tool, read active blind spot module DTCs.

Does the scan tool display U0141 - Lost Communication with LPM?

Yes

• Refer to => Non-DTC Based Diagnostics.

No

• perform the Stored Lost Communication DTCs diagnostic procedure. Stored Lost Communication DTCs Refer to => Non-DTC Based Diagnostics.