Passive Entry Antennas, Left Quarter Panel

Left Quarter Panel







Removal

- Disconnect the battery negative cable.

- Remove the trim panel from the left quarter inner panel (1)..

- Disconnect the body wire harness connector (4) from the Low Frequency (LF) antenna (6) connector receptacle.

- Remove the screw (5) that secures the LF antenna to the left quarter inner panel.

- Remove the nut (7) that secures the LF antenna to the weld stud (2) on the left quarter inner panel.

- Remove the LF antenna from the left quarter inner panel.

Installation







- Check to be certain that the plastic nut (3) is in good condition and properly installed in the left quarter inner panel (1).

- Position the Low Frequency (LF) antenna (6) to the left quarter inner panel.

- Install and tighten the nut (7) that secures the LF antenna to the weld stud (2) on the left quarter inner panel. Tighten the nut securely.

- Install and tighten the screw (5) that secures the LF antenna to the left quarter inner panel. Tighten the screw securely.

- Connect the body wire harness connector (4) to the LF antenna connector receptacle.

- Install the trim panel onto the inside of the left quarter inner panel.

- Connect the battery negative cable.