Passive Entry Antennas, Liftgate

Liftgate







Removal

- Disconnect the battery negative cable.

- Remove the trim panel from the inside of the liftgate..

- Disconnect the liftgate wire harness connector (3) from the Low Frequency (LF) antenna (4) connector receptacle.

- Remove the two screws (5) that secure the LF antenna to the liftgate inner panel (1).

- Remove the LF antenna from the liftgate.

Installation







- Check to be certain that the two plastic nuts (2) are in good condition and properly installed in the liftgate inner panel (1).

- Position the Low Frequency (LF) antenna (4) to the liftgate inner panel.

- Install and tighten the two screws (5) that secure the LF antenna to the liftgate. Tighten the screws securely.

- Connect the liftgate wire harness connector (3) to the LF antenna connector receptacle.

- Install the trim panel onto the inside of the liftgate..

- Connect the battery negative cable.