Power Liftgate Switch, D-Pillar

Power Liftgate Switch, D-Pillar

Special tools, testers and auxiliary items required

• Trim removal wedge (RMCP101)

Removing

- Disconnect and isolate the battery negative cable.

- Using trim removal wedge (RMCP101) disengage the power liftgate D-pillar switch bezel (1) from the upper D-pillar trim panel (3).






- Disconnect the switch electrical connector (4) and remove the switch.

- Using trim removal wedge (RMCP101) carefully disengage the switch bezel tabs and separate the power liftgate D-pillar switch (5) from the switch bezel (1).

Installing

- Position the power liftgate D-pillar switch (5) into the switch bezel (1) and press into position until the tabs are fully engaged.






- Position the power liftgate D-pillar switch bezel (1) into the left rear of vehicle.

- Connect the switch electrical connector (4).

- Install the switch bezel (1) into the upper D-pillar trim panel (3) until the tabs (2) are fully engaged.

- Connect the battery negative cable.

- Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes related to the power liftgate D-pillar switch.