Rear Mode Door Actuator

Rear Mode Door Actuator

Removing

- Disconnect and isolate the negative battery cable.






- Remove rear HVAC housing (1) and place it on a workbench. Refer to => [ Rear HVAC Housing ] Rear HVAC Housing.

- Disconnect the wire harness connector (2) from the rear mode door actuator (3).

- Remove the two screws (4) that secure the rear mode door actuator to the back of the rear HVAC housing and remove the actuator.

Installing






- Position the rear mode door actuator (3) onto the rear HVAC housing (1). If necessary, rotate the actuator slightly to align the splines on the actuator output shaft with those on the rear mode-air door coupler.

- Install the two screws (4) that secure the rear mode door actuator to the rear HVAC housing. Tighten the screws to 1.2 Nm (10 in lbs).

- Connect the wire harness connector (2) to the rear mode door actuator.

- Install the rear HVAC housing. Refer to => [ Rear HVAC Housing ] Rear HVAC Housing.

- Connect the negative battery cable.

- Calibrate the HVAC control.