Tire Pressure Monitoring Module, Premium System

Tire Pressure Monitoring Module, Premium System

Special tools, testers and auxiliary items required

• Tire Pressure Monitor System Diagnostic Tool (J-49225)

Removing






- Remove wheelhouse splash shield.

- Disconnect wiring harness connector (3) at the Tire Pressure Module (2).

- Remove mounting nuts (1), then remove the Tire Pressure Module (2) from body seam flange (4).

Installing






- Position the Tire Pressure Module (2) on body seam flange (4) and install mounting nuts (1).

- Connect wiring harness connector (3) at the Tire Pressure Module (2).

- Install wheelhouse splash shield and all components removed to access it.

- Perform one of the following to make the system learn the new sensor ID:

- Use the Tire Pressure Monitor System Diagnostic Tool (J-49225) , with the Scan Tool to program the TPM Module with the tire pressure sensor ID. This is part of the TPM Diagnostic Verification Test.

- Once the vehicle has remained stationary for more than 20 minutes, drive vehicle for a minimum of 20 minutes while maintaining a continuous speed above 15 mph (24 km/h). During this time, the system will learn the new sensor ID. This is part of the TPM Diagnostic Verification Test.