Through Model Year 2010

Speed Control Switch


Disconnect the negative battery cable, refer to => [ Battery, Disconnecting and Connecting ] Tools and Equipment, before beginning steering wheel removal or installation. Allow the front airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component. This will disable the front airbag system. Failure to disconnect the battery could result in accidental front airbag module deployment and possible personal injury.

Do not place a non-deployed airbag face down on a hard surface as the airbag will propel into the air if accidentally deployed, and could result in serious or fatal injury.

Removing






- Disconnect the negative battery cable, refer to => [ Battery, Disconnecting and Connecting ] Tools and Equipment, before beginning steering wheel removal. Allow the front airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component.

- Remove the steering wheel air bag.

- Disconnect the electrical connector (1) from speed control switch (3).

- Remove the screws (2) from speed control switch (3).

- Remove the speed control switch (3) from steering wheel.

Installing






- Install the speed control switch (3) to steering wheel.

- Install the screws (2) to speed control switch (3) and tighten to 1.6 Nm (15 in. lbs.).

- Connect the electrical connector (1) to speed control switch (3).

- Install the steering wheel air bag.

- Connect the negative battery cable. Refer to => [ Battery, Disconnecting and Connecting ] Tools and Equipment.

- Verify vehicle and system operation.