Body Side Moldings

Body Side Moldings

Removing






- Before removing, heat the body side moldings - 1/2 - around the adhesive tape - 3 - using the Hot Air Blower (V.A.G 1416) and remove the moldings.

Installation

• The description applies to the left side. It can also be applied to the right side.

• Only remove the protective film right before assembly. Processing temperature workshop temperature.

• Stand time after installing body side moldings is approximately 4 hours at an ambient temperature of approx. 70° F (21° C).





- Remove any adhesive residue with adhesive remover (VAS 6349).

- Clean adhesion surface thoroughly with adhesive remover D 002 000 10 immediately prior to bonding on the side protective moldings.

• The adhesive surface must be free of dust, grease and adhesive residue.

- Before installing, remove the protective foil from the adhesive tape - 3 -.

- Mount the body side moldings - 1/2 - onto the vehicle and firmly press it in the area of the adhesive tape - 3 -.