Bench Seat

Bench Seat

Removing

Vehicles with variable luggage compartment floor

- Pull the luggage compartment floor - 18 - out of the backrest panel - 17 - and remove it out of the vehicle.

All vehicles

- Remove bolts - 13 -, - 14 -, - 15 - and - 19 - (60 Nm).

- Remove the caps - 3 -, - 6 -, - 8 - and - 10 -.

- Remove the nuts - 2 -, - 5 -, - 7 - and - 9 - (60 Nm).

- Remove the trim - 1 -, - 4 - and - 11 - from the seat rails.

- Pull the left - 16 - rear bench seat forward - arrow A -.

- Lift the left rear bench seat in the front - arrow B -.

- Fold the rear backrest all the way forward, and with a second technician, remove the section from the vehicle.

• Removing the right rear bench seat - 12 - is identical.






Installation

- Install in reverse order of removal.

Perform the following function test after installing:

- Operate the forward/back adjustment; the rear bench seat must move evenly.

- Move both sections of the rear bench seat as far back as possible.

- Operate the backrest release; the backrest must fold forward on its own.

If this does not happen, remove the screws and align the rear bench seat once again.