Exhaust System, Installing

Exhaust System, Installing

• Align the exhaust system when cold.

- Loosen the nuts - 3 and 4 - on the front clamping sleeve - 1 -.






- Align the front clamping sleeve - 1 - to the mark - A - on the front exhaust pipe - 2 - (- arrow - faces in the direction of travel).

• Dimension - a - = => [ Tightening Torque and Installed Dimension of the Clamping Sleeve ] Clamping Sleeve Installed Position and Tightening Torque.

• The nuts must be at the right and must not project beyond the lower edge of the clamping sleeve.

- Hand tighten the front nut - 3 - on the clamping sleeve.

- Push the exhaust system far enough forward so that the pretension at the retaining loop for the rear muffler equals dimension - a - = 15 to 17 mm.






- In this position, evenly tighten the nuts - 3 and 4 - on the clamping sleeves. Tightening specifications, refer to => [ Tightening Torque and Installed Dimension of the Clamping Sleeve ] Clamping Sleeve Installed Position and Tightening Torque.






Clamping Sleeve Locations





- Install the clamping sleeve so that the bolt end - arrow - does not project beyond the lower edge of the clamping sleeve.

• Threaded connection points toward the right.