Heating Components Overview
Heating Components Overview
Disconnect the battery before removing components marked with a **.
1 Dash Panel **
2 Center Vents
• Removing vents, refer to => [ Center Vent ] Center Vent.
3 Passenger Vent
• Removing vents, refer to => [ Driver or Passenger Vents ] Driver or Passenger Vents.
4 Fresh Air and Heated Air Controls
• With Fresh air/recirculating door switch (E159).
• Also with Immediate heating button (E537) in vehicles with an auxiliary heater.
• Removing controls, refer to => [ Heat and Fresh Air Controls ] Heat and Fresh Air Controls.
• On vehicles with heated seats also with Heated driver seat adjuster (E94) and Heated front passenger seat adjuster (E95).
5 Fresh/Recirculating Air Door Motor (V154)
• Removing and installing, refer to => [ Fresh/Recirculating Air Door Motor (V154) ] Fresh/Recirculating Air Door Motor (V154).
6 Right Footwell Vent
• Removing and installing, refer to => [ Right Footwell Vent ] Right Footwell Vent.
7 Fresh Air Blower (V2)
• Removing and installing, refer to => [ Fresh Air Blower (V2) ] Service and Repair.
8 Fresh Air Blower Series Resistor With Fuse (N24)
• Removing and installing, refer to => [ Fresh Air Blower Series Resistor With Fuse (N24) ] Service and Repair.
9 Heater Partition
• Removing and installing, refer to => [ Heater Partition ] Heater Partition.
10 Sealing Caps
• Only in vehicles without air duct to vent installed in center console at rear.
11 Air Guide
• Disassemble the center console in order to remove it. Refer to Storage Compartments, Covers and Trim.
12 Dust and Pollen Filter
• With EVAP canister.
• Removing and installing, refer to => [ Dust and Pollen Filter ] .
13 Connection
• For the center console air duct.
• Disassemble the center console in order to remove it. Refer to Storage Compartments, Covers and Trim.
14 Air Outlet Grille
• Depending on vehicle equipment.
15 Rear Channel For Right Footwell
• Removing and installing, refer to => [ Rear Footwell Channel ] Rear Footwell Channel.
16 Rear Channel For Left Footwell
• Removing and installing, refer to => [ Rear Footwell Channel ] Rear Footwell Channel.
17 Screw
• Quantity: 8
18 Adapter For Controls
19 Heater Core
• Replace all the coolant after replacing the heater core.
• Removing and installing, refer to => [ Heater Core ] Heater Core.
20 Left Footwell Vent
• Removing and installing, refer to => [ Left Footwell Vent ] Left Footwell Vent.
21 Bowden Cable For Temperature Door
• Removing and installing, refer to => [ Temperature Door Release Cable ] Service and Repair.
22 Flexible Shaft
• Removing and installing, refer to => [ Flexible Air Distribution Shaft ] Flexible Air Distribution Shaft.
23 Heater Unit
• Removing and installing, refer to => [ Heater Unit ] Heater Unit.
• Disassembling and assembling, refer to => [ Heater Unit ] Heater Unit.
Installation Position Of Seal For Heater and Engine Compartment
- First insert the seal into the plenum chamber bulkhead between the heater and engine compartment - A - and then place on the heater core.
• To prevent water from entering vehicle interior, note the installation position.