Reverse Gear Wheel Stop Ring and Spring

Reverse Gear Wheel Stop Ring and Spring

Special tools, testers and auxiliary items required

• Thrust Plate (VW 401)

• Thrust Disc (VW 412)

• Carrier Bearing Installation Tool (3350)

Removing

- Remove the stop ring - A - from the reverse gear - C - using a drift.






When doing this, secure the spring - B - from jumping away.

Installing

- First, install the spring - B - in the gear - C -.

• The bent end of spring - arrow 1 - must be hooked into hole - arrow 2 - of the gear.

- Then install the stop ring - A - on the gear.

• The recesses in the stop rings - arrows 3 - and in the gear - 4 - must align with each other.

- Carefully install the stop ring - A - onto the gear. Hold the spring - arrows - compressed when doing this.






- Then secure the stop ring - A - on the gear with a blunt center punch - B -.






- When doing this, place the center punch in the groove - arrow - in the gear.