Clamping Sleeve Installed Position and Tightening Torque

Clamping Sleeve Installed Position and Tightening Torque

• Gradual introduction of clamping sleeves with a continuous clamp.

Tightening Torque and Installed Dimension of the Clamping Sleeve





Clamping sleeve - A - with 2 individual clamps.

Tightening specification: 25 Nm

Installation dimension - a - 5 mm (only for the front clamping sleeve)

Clamping sleeve - B - with a continuous clamp.

Tightening specification: 35 Nm

Installation dimension - a - 8.5 mm (only for the front clamping sleeve)

Installed Dimension - a - for Vehicles with a Mark on the Front Exhaust Pipe





1 Clamping sleeve
2 Front exhaust pipe
a Installed dimension
A Mark

Installed Position of the Front Clamping Sleeve





- Install the clamping sleeve so that the bolt end - arrow - does not project beyond the lower edge of the clamping sleeve.

• Threaded connection points toward the right.

Installed Position of the Rear Clamping Sleeve





- Install the clamping sleeve so that the bolt end - arrow - does not project beyond the lower edge of the clamping sleeve.

• Threaded connection points to the rear