Headlamp Range Control Positioning Motor

Headlamp Range Control Positioning Motor

• If the motors are removed and installed again or replaced, check the headlamp adjustment and adjust it again if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.

• The illustrations show the procedure for removing and installing the right headlamp beam adjusting motor.

• The same procedure is used to remove and install Left headlamp beam adjustment motor (V48) and Right headlamp beam adjustment motor (V49).

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove the low beam headlamp. Refer to => [ Low Beam Bulb ] Low Beam Bulb.

- Rotate the headlamp beam adjustment motor - 1 - in the - direction of the arrow - as far as the stop to release it.






- Raise the headlamp beam adjustment motor - 1 - in the - direction of the arrow - approximately 1 cm up from its retainer - 2 -.






• A rubber ring holds the adjustment motor relatively tightly in its retainer.

• Lifting the reflector makes it easier to lift the adjustment motor out of its retainer.

• it is not possible to tilt the ball head out as described below without lifting the adjustment motor out of its retainer.

• Make sure the adjustment motor is in its locked position when lifting it.

- Tip the headlamp beam adjustment motor - 1 - in - direction of arrow - to pivot the motor ball head out of the mount.






- Remove the headlamp beam adjustment motor - 1 - out of the headlamp housing. Be careful of the connected wires.

- Disconnect connector - 1 - and remove headlamp beam adjusting motor - 2 -.






Installation

Install in reverse order of removal. Note the following:


When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

- Connect the connector on the headlamp beam adjustment motor.

- Position the headlamp beam adjustment motor - 1 - with the ball head - 2 - on the mount - 3 -.






- Tip the headlamp beam adjustment motor - 1 - as illustrated and pivot the ball head into the ball head mount from behind.






• Lifting the reflector at the same time makes it easier to pivot the ball head into the ball head mount.

- Position the headlamp beam adjustment motor - 1 - in the locked position on the retainer - 2 - and turn it in - direction of the arrow - to lock it.






- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.