Differential Lock Control Module

Differential Lock Control Module

Removing

- First check whether a coded radio is installed. In this case, find out anti theft coding.

- Switch the ignition and all electrical consumers off, and remove the ignition key.

- Disconnect the ground terminal connector from the battery.

- Remove left rear side trim..

With 4 Zone Climatronic

- Move the rear auxiliary heater and air conditioner unit into the service position.

Continuation for All

- Separate the connector - 1 - at differential lock control module (J647).





- Remove the bolt - 2 -.

- Unclip holder with differential lock control module (J647) - 3 - from structure - arrows - and remove holder with differential lock control module (J647).

Installing

Install in reverse sequence; note the following points:

- First, clip the holder with differential lock control module (J647) - 3 - into structure - arrows -.





- Then, fasten the bolt - 2 - to 2 Nm.

- Connect ground terminal connector to battery and perform the work sequences after connecting the battery.