Headlamp Range Control Positioning Motor

Headlamp Range Control Positioning Motor

• If adjusting motors for headlamps with automatic vertical headlamp aim control are removed and installed or replaced, basic setting of headlamps must be performed. Refer to Maintenance Procedures; Rep. Gr. 03.

• Illustrations depict replacement of headlamp beam adjusting motor at left headlamp.

• Replacement procedure of Left Headlamp Beam Adjustment Motor (V48) and of Right Headlamp Beam Adjustment Motor (V49) is the same.

Removal

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove bolt - 1 - and press adjusting shaft for low beam and high beam height adjustment - 2 - in - direction of arrow - out of guide.






- Pull adjusting shaft for low beam and high beam height adjustment - 2 - out of headlamp housing.

- Press wire bracket - 1 - to the side in - direction of arrow - and remove cover cap - 2 -.






- Disconnect connector - 3 -.






- Remove mounting bolts - 1 -.

- Press the headlamp beam adjusting motor - 2 - toward left in order to pull out adjusting axle ball head laterally out of ball head mount at reflector.

- Remove headlamp beam adjusting motor - 2 - out of headlamp housing.

Installation

Install in reverse order of removal. Note the following:

• When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

• If adjusting motors for headlamps with automatic vertical headlamp aim control are removed and installed or replaced, basic setting of headlamps must be performed. Refer to Maintenance Procedures; Rep. Gr. 03.

- Insert adjusting axle of headlamp beam adjusting motor - 1 - carefully into ball head guide - arrow -.






- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.