Low Beam Bulb

Low Beam Bulb

• Left Low Beam Headlamp (M29) and Right Low Beam Headlamp (M31) can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519). Refer to => [ Vehicle Electrical System, Output Diagnostic Test Mode ] Scan Tool Testing and Procedures.

• The following illustrations show the procedure for replacing the low beam headlamp bulb.

• The same procedure is used to remove and install the left low beam headlamp and right low beam headlamp.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- Remove the cap - 1 - from the rear side of the headlamp.






- Turn the lamp socket with the low beam headlamp bulb - 1 - in the - direction of the arrow - and remove it back from the reflector. Be careful of the connected wires when doing this.






- Remove the low beam headlamp bulb - 2 - from the bulb socket - 1 -.






Low beam headlamp bulb 12V, 55 W

Installation


When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

Install in reverse order of removal. Note the following:

- Check headlamp for function.

- Check the headlamp adjustment and correct it if necessary. Refer to Maintenance Procedures; Rep. Gr. 03.