Interior Monitoring Deactivation Switch E267 and Deactivate Vehicle Inclination Sensor Button E360

Interior Monitoring Deactivation Switch E267 and Deactivate Vehicle Inclination Sensor Button E360

Special tools, testers and auxiliary items required

• Removal Wedge (3409)

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( (3409) , screwdriver) will be positioned, using commercially available adhesive tape.

• To remove the Interior Monitoring Deactivation Switch and Deactivate Vehicle Inclination Sensor Button, anti-theft alarm system must be deactivated.

• The interior monitoring deactivation switch and deactivate vehicle inclination sensor button compose one component.

• The interior monitoring deactivation switch and the deactivate vehicle inclination sensor button are located in the B-pillar trim on the driver side.

The following components are integrated in the interior monitoring deactivation switch:

• Interior Monitoring -Off- Indicator Lamp (K162)

• Interior Monitoring Deactivation Switch Illumination (L118)

The following components are integrated in the deactivate vehicle inclination sensor button:

• Interior Monitoring -Off- Indicator Lamp (K162)

• Push Button Illumination (L76)

The Interior Monitoring -Off- Indicator Lamp and Vehicle Inclination Sensor Indicator Lamp (K188) can be checked via output Diagnostic Test Mode (DTM) of the Comfort System Central Control Module (J393). Refer to => [ Output Diagnostic Test Mode (DTM) ] Output Diagnostic Test Mode (DTM).

Removing

- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

- Carefully pry out interior monitoring deactivation switch and deactivate vehicle inclination sensor button using (VAS 3409) or a screwdriver.






- Disengage harness connector - arrow - and disconnect it.






Installing

Install in reverse order of removal.