Center Console Switches

Center Console Switches

Special tools, testers and auxiliary items required

• Removal Wedge (3409)

The same procedure is used to remove and install the following components. The procedure is only described for one component.

• ASR/ESP Button (E256)

• -AUTO HOLD- Button (E540)

• Parking Aid Button (E266)

• Parallel Parking Assistance Button (E581)

• Tire pressure monitoring button (E226)

• Dampening adjustment button (E387)

• Rear Window Shade Switch (E149)

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( (3409) , screwdriver) will be positioned, using commercially available adhesive tape.

• The following illustration shows the procedure for removing and installing in a vehicle with a manual transmission. The procedure for removing and installing the switch in the center console is the same in vehicles with a DSG or automatic transmission.

Removing

- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

- Carefully pry the trim - 1 - upward. Be careful of the connected wires.






- Disconnect and release all the connectors and remove the trim - 1 -.

- Release the retainers on both sides and press the button up out of the trim.

Installing

Install in reverse order of removal. Note the following:

• The button connectors are color-coded to make them easier to assign.