Fuel Pump Control Module J583

Fuel Pump Control Module J583

• The fuel pump control module is located on the fuel tank.

Special tools, testers and auxiliary items required

• Flat Blade Screwdriver (blade length 120 mm)

Installed location of the fuel pump control module:






1 Fuel pump control module bracket
2 Fuel pump control module
3 Connector

Removing

- Remove the cover that is on the right side of the fuel delivery unit, when viewed in the direction of travel.

- First, pull on the 5 pin connector - 1 - without pressing the release to make sure it is connected securely. If the connector was not connected correctly, it could cause a fault.






- Disconnect the connector - 1 -.

- Check the contacts on the connector and the fuel delivery unit for damage.

- Push the screwdriver - 2 - into the opening in the bracket - 1 - directly above the connector.






- Swivel the screwdriver in the - direction of the arrow -.

- Press the screwdriver downward in the - direction of the arrow - and pull the control module out of the bracket at the same time.






- First pull on the connector without pressing the retainer to make sure it is connected securely. If the connector was not connected correctly, it could cause a fault.

- Disconnect the connector from the control module.

Installing

- Connect the connector - 3 - to the control module - 2 - and pull on it to make sure it is connected securely.






- Mount the control module - 2 - into the bracket - 1 - until it latches.

Further installation is performed in the reverse order of removal.