Parking Aid Control Module J446, through 05.08

Parking Aid Control Module J446, through 05.08

Coding the parking aid control module, through 05.08

The parking aid control module is located behind side panel trim in luggage compartment, right side.

Removing

- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

- Remove the cover on the right side trim in the luggage compartment.

• For clearer illustration, component location of parking aid control module is depicted with the side wall trim removed.

- Disengage and disconnect harness connectors - 2 -.






- Press together retaining lugs of retaining pins - arrows - on both sides of parking aid control module and pull off parking aid control module - 1 - from retaining pins.

Installing

Install in reverse order of removal.

Coding the parking aid control module (J446) through 05.08

Via coding, the parking aid control module can be specifically adjusted to the demands of the vehicle at hand.

- Connect the Vehicle Diagnostic Tester. Refer to => [ Vehicle Diagnosis, Testing and Information Systems ] Vehicle Diagnosis, Testing and Information Systems.

- On the Vehicle Diagnostic Tester, select "Guided Fault Finding".

- Using the "GO TO" button, select "Functions/Component selection" and the following menu options in sequence:

• Body

• Body repair procedures

• 01 - On Board Diagnostic (OBD) capable systems

• Parking Aid

• Parking assistance functions

• Coding parking aid system