Rear Shelf Lock Sensors

Rear Shelf Lock Sensors

• All screws are microencapsulated and must always be replaced.

• Sensor consists of 2 parts, magnet is secured on locking hooks in assembly carrier.






- Run roof with convertible top opening switch until rear lid with rear shelf is open halfway.

- Remove screw - 2 - and remove sensor - 1 - from locking bracket - 4 -.

When replacing sensor, disconnect wire - 3 - approximately 350 mm from sensor, behind corner. Wiring harness repair description. After repairing wiring harness, wiring must be secured in harness again.

Tighten screws - 2 -: 3 Nm.