Front Turn Signal Bulbs

Front Turn Signal Bulbs


• Note usage and safety notes for halogen lamps, refer to => [ Application and Safety
Notes ] Halogen Headlamps.

• During removal and installation, leave ignition key with remote control inside the vehicle to prevent the doors from locking and possibly activating the Coming Home / Leaving Home functions on its own.

Removal

In order to be able to replace the bulb, it is sometimes necessary to remove neighboring components at the corresponding headlamp.

- Refer to the following table as to which components are to be removed depending on engine version, in order to replace the bulb.






• The following figures show the replacement of the right headlamp bulb.

• The left headlamp bulb is replaced is the same way.

- Twist off housing cover - 4 -.






The bulb socket - 2 - is secure to the reflector - 1 - with a bayonet connection.






- Rotate lamp socket - 2 - with the front turn signal bulb counterclockwise and remove it from the reflector.

- Push front turn signal light - 2 - into socket - 1 - and rotate front turn signal light in direction of arrow.






- Remove Front Turn Signal Light - 2 - from socket - 1 -.

Installation

Install in reverse order of removal, noting the following:






- When installing, ensure bulb socket retaining tab - A - is inserted in the reflector groove - B -.

• The tab - arrow A - must face upward during installation.

- Then press bulb socket against reflector and tighten socket by turning clockwise.

• When installing housing cover, check for proper fitting. It is destroyed by entry of water into headlamp.

- Check headlamp for function.