Shift Forks

Shift Forks

Special tools, testers and auxiliary items required

• Thrust Plate (VW 402)

• Punch (VW 411)

• Tube Trans. Drive Shaft (VW 426)

• Thrust Pad 16.5/28 mm Dia. (VW 431)

• Kukko Extractor 18.5-23.5 mm (21/3)

• Kukko Support (22/1)






1 Insulation Mat

• Can be removed and installed by hand.

2 Selector Shaft with Selector Fork, for 1st and 2nd Gear

3 Selector Shaft with Selector Fork, for 3rd and 4th Gear

4 Selector Shaft with Selector Fork, for 5th and 6th Gear

• On some transmissions, it is also for the reverse gear selector fork bearing.

5 Reverse Gear Selector Fork

• On the shaft for the reverse gear selector fork, refer to => [ Reverse gear selector fork mounted on the selector shaft behind the 5th and 6th gear selector shaft : ] Transmission, with a Sealing Cap Circlip for the Input Shaft.

• From transmission manufacture date 6 March 2006, ball sleeve => [ (Item 6) Ball Sleeve ] , has been deleted.

• Sliding deletion.

• Reverse gear selector fork is adapted.

• If the shaft for the reverse gear selector fork is deleted, the bearing on the selector shaft for the 5th and 6th gear selector fork. Refer to => [ Reverse gear selector fork mounted on the selector shaft with the 5th and 6th gear selector fork : ] Transmission, with a Sealing Cap Circlip for the Input Shaft.

• Reverse gear selector fork differentiation, refer to => [ Reverse Gear Selector Fork Differentiation ].

• Refer to the Parts Catalog.

6 Ball Sleeve

• Removing, refer to => [ Through Transmission Build Date 5 March 2006 - Remove the Reverse Gear Selector Fork Ball Sleeve ].

• Installing, refer to => [ Through Transmission Build Date 5 March 2006 - Press in the Reverse Gear Selector Fork Ball Sleeve ].

• From transmission manufacture date 6 March 2006, the ball sleeve has been deleted.

• Sliding deletion.

Reverse Gear Selector Fork Differentiation










Through Transmission Build Date 5 March 2006 - Remove the Reverse Gear Selector Fork Ball Sleeve





A Internal puller 18 to 23 mm, for example, Kukko extractor 18.5-23.5 mm (21/3)
B Counter support, for example, Kukko support (22/1)

Through Transmission Build Date 5 March 2006 - Press in the Reverse Gear Selector Fork Ball Sleeve