Window Regulator Basic Setting

Window Regulator Basic Setting

• Window regulator motor must operate with greatest possible operating force for window regulator basic setting. Therefore, it is necessary to leave the engine running.

Procedure for window regulator basic setting:

• Start engine.

• Completely lower side window.

• Close side window and block with hand. Side window lowers (reverses).

• Close side window again within 5 seconds and block with hand again. Side window stops.

• Close side window again within 5 seconds. Side window runs without pinch protection up to mechanical window regulator stop.

• Within 5 seconds, hold window regulator switch for 5 seconds. Now window regulator motor is adjusted to window regulator.

The following 3 side window to door window positions are possible:

• Side window runs up to height of door window. Side window adjustment is correct.

• Side window does not run up to height of door window. The side window must be corrected in height adjustment toward top, refer to => [ Adjusting Height and Parallel Alignment ] Adjusting Height and Parallel Alignment

• The side window runs higher than the door window. Side window must be corrected in height adjustment toward bottom, refer to => [ Adjusting Height and Parallel Alignment ] Adjusting Height and Parallel Alignment. Perform basic setting again after correction.