Headlamp Range Control Positioning Motor, Valeo

Headlamp Range Control Positioning Motor, Valeo

Removal

• Whenever a positioning motor is removed, installed or replace, it is always necessary then to check the headlamp position and adjust it if necessary.

• Illustrations depict replacement of headlamp beam adjusting motor at right headlamp.

• Replacing the left headlamp range control positioning motor is identical.

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove headlamp. Refer to=> [ Halogen Headlamps ] Halogen Headlamps.

- Pull the clip - 1 - upward and remove the cap - 2 - from the back of the headlamp.






- Turn the adjustment screw - 1 - for adjusting the low beam lamp vertically in the following direction:






• Left headlamp - all around to the left

• Right headlamp - all round to the right

- Lift the adjustment screw - 1 - with a screwdriver and pull it out of the headlamp housing.

- Disconnect the connector - 2 - from the headlamp range control positioning motor.

- Move the headlamp range control positioning motor - 1 - all the way in - direction of arrow - to unlock it.






- Tip the headlamp range control positioning motor - 3 - so that it is possible to swing the ball head - 1 - downward and out of the ball head mount - 2 -.






- Remove headlamp beam adjusting motor out of headlamp housing.

Installation

Install in reverse order of removal, noting the following:

- Insert the headlamp range control positioning motor into the headlamp.

- Connect the connector.

- Carefully swing the ball head - 1 - back into the ball head mount - 2 -.






- Turn the motor - 3 - to the left all the way to lock it into place.

• Make sure the O-ring is installed correctly when inserting the low beam vertical adjustment screw.

- Insert the low beam vertical adjustment screw back into the headlamp housing.


When installing the cover cap, make sure the cap is properly seated. It is destroyed by entry of water into headlamp.

- Install the cap - 2 - and clip - 1 -.






- Check headlamp for function.

- Adjust the headlamp.

- Check the headlamp setting and adjust if necessary.