Passenger Compartment Component Location Overview, Climatic Through 27 May 2011
Passenger Compartment Component Location Overview, Climatic through 27 May 2011
• Disconnect the battery before removing components marked with a **.
• A data plate on the lock carrier indicates the refrigerant used and capacity.
• If the lamp in the AC button does not come after the button is pushed, there may be a fault in the control module. Call up the DTC memory with the Vehicle Diagnostic Tester. If the fault entry "A/C compressor first start not performed" is present, then is it necessary to perform a basic setting and an adaptation "A/C compressor first start" either in Guided Fault Finding or in Guided Functions.
• Perform an adaptation "A/C compressor first start " either in Guided Fault Finding or in Guided Functions when installing a new A/C control module (J301).
1 Dash Panel **
2 Center Vent
• Removing and installing, refer to => [ Center Vent ] Center Vent.
3 Right Side Vent
4 Air Outlet
• Removing and installing, refer to => [ Driver Side or Front Passenger Side Vent ] Driver Side or Front Passenger Side Vent.
5 "Climatic" Heating And A/C Controls With A/C Control Module (J301)
• With fresh air/recirculating door switch (E159)
• Also with immediate heating button (E537) in vehicles with an auxiliary heater
• With rear window defogger switch (E230)
• On vehicles with heated seals also with heated driver seat adjuster (E94) and heated front passenger seat adjuster (E95)
• Removing and installing, refer to => [ Display and Control Unit, Electric Manual ] Display and Control Unit, Electric Manual.
• Replacing: the basic setting and an adaption "A/C compressor first start" must occur in the Guided Fault Finding or in Guided Functions using the Vehicle Diagnostic Tester.
6 Recirculation Door Motor (V113)
• Checking: use the vehicle diagnostic tester
• Removing and installing, refer to => [ Recirculation Door Motor (V113) ] Recirculation Door Motor (V113).
• Replacing: initiate the basic setting using the vehicle diagnostic tester.
7 Front Passenger Side Footwell Vent
• Removing and installing, refer to => [ Passenger Side Footwell Vent ] Passenger Side Footwell Vent.
8 Fresh Air Blower (V2)
• Removing and installing, refer to => [ Fresh Air Blower (V2), Manual Controls ] Fresh Air Blower (V2), Manual Controls.
9 Fresh Air Blower Series Resistor With Fuse (N24)
• Removing and installing, refer to => [ Fresh Air Blower Series Resistor with Fuse (N24) ] Service and Repair.
10 Heating Unit Partition
11 Evaporator Temperature Sensor (G308) or Evaporator Vent Temperature Sensor (G263)
• Checking: use the vehicle diagnostic tester
• One or both of the component designations will appear, depending on software. The tasks are the same.
• Removing and installing, refer to => [ Evaporator Temperature Sensor (G308) or Evaporator Vent Temperature Sensor (G263) ] Service and Repair.
12 Connection
• For the air duct
• It is necessary to remove the center console first in order to remove the connection.
13 Dust and Pollen Filter
• With activated charcoal filter
• Removing and installing, refer to => [ Dust and Pollen Filter ] .
14 Rear Channel Footwell
• Removing and installing, refer to => [ Rear Channel, Footwell ] Rear Channel, Footwell.
15 Rear Channel Footwell
• Removing and installing, refer to => [ Rear Channel, Footwell ] Rear Channel, Footwell.
16 Screw
• Quantity: 4
17 Auxiliary Air Heater Heating Element (Z35) **
18 Heater Core
• Removing and installing, refer to => [ Heater Core ] Service and Repair.
19 Driver Side Footwell Vent
• Removing and installing, refer to => [ Driver Side Footwell Vent ] Driver Side Footwell Vent.
20 Temperature Regulator Door Motor (V68)
• Checking: vehicle diagnostic tester
• Removing and installing, refer to => [ Temperature Regulator Door Motor (V68) ] Temperature Regulator Door Motor (V68).
• Replacing: initiate the basic setting using the vehicle diagnostic tester.
21 Air Distribution Door Motor (V428) with Air Distribution Door Motor Position Sensor (G645)
• Checking: use the vehicle diagnostic tester
• Removing and installing, refer to => [ Air Distribution Door Motor (V428) ] Air Distribution Door Motor (V428).
• Replacing: initiate the basic setting using the vehicle diagnostic tester.
22 Footwell Outlet Temperature Sensor (G192)
• Removing and installing, refer to => [ Footwell Vent Temperature Sensor (G192) ] Footwell Vent Temperature Sensor (G192).
23 Heating and A/C unit
• Removing and installing, refer to => [ Heater and A/C Unit ] Removal and Replacement.
• Disassembling and assembling, refer to => [ Heater and A/C Unit Overview, Climatic ] Heater and A/C Unit Overview, Climatic.
24 Side Vent
25 Center Outlet Temperature Sensor (G191)
• Removing and installing, refer to => [ Center Vent Temperature Sensor (G191) ] Center Vent Temperature Sensor (G191).