Selector Forks Overview

Selector Forks Overview

• The selector fork group (- item 7 -) does not need to be disassembled to remove and install shift segments, lock washers and angular contact ball bearings.






1 5th Gear Shift Segment

• Identification, refer to => [ Shift Segment Identification ] Selector Forks.

• The shift segment must still rotate easily after the lock washer is installed.

2 Lock Washer

• Always replace.

• Removing, refer to => [ Removing the Lock Washer ] Selector Forks.

• Installing, refer to => [ Installing the Lock Washer ] Selector Forks.

3 5th Gear Selector Fork

4 Bolt, 25 Nm

5 5th Gear Shift Jaw

6 Angular Contact Ball Bearing

• Quantity: 4

• Removing, refer to => [ Removing the Angular Contact Ball Bearing ] Selector Forks.

• Pressing the bearing inner race into the outer race. Refer to => [ Installing the Angular Contact Ball Bearing Inner Race into the Outer Race ] Selector Forks.

• Installing, refer to => [ Installing the Angular Contact Ball Bearing into the Selector Fork ] Selector Forks.

7 Selector Fork with Rails

8 1st/2nd Gear Shift Segment

• Identification, refer to => [ Shift Segment Identification ] Selector Forks.

• The shift segment must still rotate easily after the lock washer is installed.

9 3rd/4th Gear Shift Segment

• Identification, refer to => [ Shift Segment Identification ] Selector Forks.

• The shift segment must still rotate easily after the lock washer is installed.

10 Gliding Piece

11 Spring

12 Reverse Gear Selector Fork

13 Support for the Reverse Gear Selector Fork

14 Locking Ring