Installation Unit

Installation Unit


Only remove and install drive motor for sunroof glass panel when roof is closed (zero position).

Requirements for removing and installing the drive: the engine and the ignition must be off, remove the key and open the door.

Removing






- Remove headliner.

- Disconnect water drain hoses - 4 - from installation unit - 1 -.

- Disconnect harness connector - 3 - from drive motor of glass panel for sunroof - 5 -.

- Remove bolts - 2 - and remove installation unit - 1 - from vehicle with a second mechanic.

Installation






- With a second mechanic, insert installation unit - 1 - into roof cutout.

- During installation, align installation unit - 1 - via two cylindrical pins (reversed drill bit) 12 mm at right front - arrow - and 10 mm left rear - arrow - in roof.

Installation unit must not make contact with roof frame.

- Insert bolts - 2 -.

- Check wires and harness connectors for electrical consumers at roof for correct routing and reproduce if necessary.

- Firmly bolt (8 Nm) installation unit - 1 - of drive motor for sunroof - 5 - beginning at left and right toward rear.

- Install water drain hoses - 4 -.

- Connect harness connector - 3 - for drive motor of glass panel for sunroof - 5 -.

- Install headliner..