Defroster Door Motor (V107)

Defroster Door Motor (V107)

Special tools, testers and auxiliary items required

• Vehicle Diagnostic Tester or newer model.

Perform the following work first:

- Turn off all electric consumers.

- Switch off the ignition.

- Remove the key.

Removing

- Remove the instrument panel.

- Remove the data bus on board diagnostic interface (J533).

- Remove the bolts - 1 - and - 3 - (9 +/- 1.3 Nm).






- Remove the bracket - 2 -.

- Mark the connector - C - for the motor (danger of confusing it with other connectors that may look the same).






- Disconnect the connector - C - from the defroster door motor.

- Remove securing bolts - A - and remove defroster door motor - B -.

- Disconnect the lever - E - from the connecting rod - D -.

Installing

Install in reverse order of removal. When doing this, note the following:






- The tightening specification for the screws - 1 - and - 3 - is 9 +/- 1.3 Nm.

- After installing, function of defroster door must be checked. Initiate the "basic setting" using the vehicle diagnostic tester.