Rear Lid Tail Lamps with LEDs

Rear Lid Tail Lamps with LEDs

Rear Lid Tail Lamps with LEDs Assembly Overview

• The left tail lamp assembly in the rear lid has two LED modules that control the tail lamps and the fog lamps.

• The fog lamp LED module is located in the left tail lamp only on vehicles for RHD traffic; on vehicles for LHD traffic, the fog lamp bulb is located in the right tail lamp; USA and Canada vehicles do not have a rear fog lamp.

Left tail lamp assembly overview






1 Nuts

• 3 Nm

2 Connector

3 Rear Lid Tail Lamps with LEDs

• Removing and Installing, refer to => [ Rear Lid Tail Lamps with LEDs, Removing and Installing ]

• Checking => [ Rear Lid Tail Lamps with LEDs, Checking ]

• The right tail lamp assembly in the rear lid has one LED module that controls the tail lamps.

• The right back-up lamp (M17) is located only in the right tail lamp in RHD vehicles and only in the left tail lamp on LHD vehicles.

Right tail lamp assembly overview






1 Nuts

• 3 Nm

2 Connector

3 Bulb holder

• Removing and Installing, refer to => [ Right Back-Up Lamp Bulb, Removing and Installing ]

4 Right Back-Up Lamp (M17)

• 12V, P 21 W

• Removing and Installing, refer to => [ Right Back-Up Lamp Bulb, Removing and Installing ]

• Checking => [ Rear Lid Tail Lamps with LEDs, Checking ]

5 Rear Lid Tail Lamps with LEDs

• Removing and Installing, refer to => [ Rear Lid Tail Lamps with LEDs, Removing and Installing ]

• Checking => [ Rear Lid Tail Lamps with LEDs, Checking ]

Rear Lid Tail Lamps with LEDs, Removing and Installing

• Removing and installing the left tail lamp assembly is shown in the illustration. Removing and installing the right tail lamp assembly is identical.

Removing:

- Turn off the ignition and all electric consumers and remove the key.

- Unclip cover - 1 - in direction of - arrow - from panel.






- Disconnect the connector - 1 -.






- Remove nuts - 1 -.






- Remove the tail lamp assembly from the body opening in the rear lid - 1 - in - direction of arrow -.






Installing:

Install in reverse order of removal. Note the following:

- Install the tail lamp assembly into the body opening inside the rear lid - 1 - in - direction of arrow -.






- Tighten the nuts to the tightening specification given in the assembly overview. Refer to=> [ Rear Lid Tail Lamps with LEDs Assembly Overview ].

- Connect the connector. It must audibly engage.

- Check the gap dimensions in the body and make sure the tail lamps work correctly.

Right Back-Up Lamp Bulb, Removing and Installing

• The right back-up lamp (M17) is located only in the right tail lamp in RHD vehicles and only in the left tail lamp on LHD vehicles.

• Removing and installing the right back-up lamp (M17) is shown in the illustration. Removing and installing the left back-up lamp (M16) on LHD vehicles is identical.

Removing:

- Turn off the ignition and all electric consumers and remove the key.

- Unclip cover - 1 - in direction of - arrow - from panel.






- Turn the bulb holder - 1 - for the right back-up lamp (M17) in - direction of arrow - and remove the bulb holder from the tail lamp assembly.






- Carefully remove the right back-up lamp bulb (M17) - 2 - from the bulb holder - 1 - in - direction of arrow -.






Installing:

Install in reverse order.

Rear Lid Tail Lamps with LEDs, Checking

The tail lamps and the right back-up lamp (M17) in the rear lid can be checked using the vehicle electrical system control module (J519) output diagnostic test.