Side Panel Tail Lamps

Side Panel Tail Lamps

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Open the side trim panel - 1 - in - direction of arrow -.






- Disconnect the connector - 1 -.






- Remove the screw - 2 - and remove the tail lamp assembly inside the side panel through the opening in the body.

Installation

Install in reverse order of removal, noting the following:

• When inserting the tail lamp assembly into the opening in the body, be sure to slide it into the upper - 1 - and lower - 2 - guides correctly.






- Install the screws by hand (2.5 Nm maximum) and connect the connector.

- Check the gap dimensions in the body and make sure the tail lamps work correctly.