Tires, With Run-Flat Tires, Tires, Mounting

Tires, Mounting


• Pay attention to the instructions for warming-up cold tires to the minimum mounting temperature => [ Wheel and Tire Assembly Requirements ] Wheel and Tire Assembly Requirements

• Note the safety precautions => [ Run-Flat Tires Safety Precautions ] Service Precautions

- Coat rim flanges, tire beads and inside of upper tire beads thoroughly with tire mounting paste.

- Turn disc wheel on tire mounting device so that tire valve/tire pressure sensor - 1 - stands on opposite side of mounting head - 2 -.






- Let the tire dismounting/mounting machine run clockwise.

- Mounting of the lower bead ends before the tire valve/tire pressure sensor - arrow - to prevent damage to tire pressure sensor.






• Tire bead now slips over the rim flange. Wheel may be turned only as far until mounting head is located just in front of tire valve/tire pressure sensor - arrow -.

- Turn disc wheel on tire mounting device so that tire valve/tire pressure sensor - 1 - stands on opposite side of mounting head - 2 -.






- Install press holders - 3 - on disc wheel.

- Make sure tire bead fits correctly on mounting head and let mounting device run clockwise.

- Mounting of the upper bead ends before the tire valve/tire pressure sensor - arrow - to prevent damage to tire pressure sensor.






• Tire bead now slips over the rim flange. Wheel may be turned only as far until mounting head is located just in front of tire valve/tire pressure sensor - arrow -.

- Remove press holders from rim flange.

- Inflate tire to an inflation pressure of maximum 3.3 bar (spring pressure).


If tire beads do not make contact completely on disc wheel edge, pressure must not be increased under any circumstances.

Pre-damage to tire or disc wheel would result.

- If tire beads do not make contact completely on disc wheel edge, then release air, press off tire bead once more and coat rim flange thoroughly again with tire mounting paste.

- Inflate tire to an inflation pressure of maximum 3.3 bar (spring pressure).

- If tire beads make contact on bead seat without problems, then increase inflation pressure to 4 bar to settle tire.

- Install a new nickel-plated valve insert and fill the tire to the specified pressure.

- Then balance wheel.

- Install wheel and tighten it to tightening specification. Refer to => [ Wheel Bolt Tightening Specification ] [1][2]Specifications.