Rear Door Window

Rear Door Window

• The following describes removing and installing the right rear door window. Removing and installing the left rear door window is identical.

Removing






- Remove rear door trim..

- Remove cover cap - 5 -.

- Lower door window until spreader pin - 4 - and spreader plug - 3 - are accessible in window regulator cut-out.

• If the work step is not possible due to a malfunction via the electrical window regulator, window regulator motor can be unscrewed - 8 - to be able to slide window down.

- Install a 5 mm bolt (approximately 70 mm long) into the spreader pin - 4 - and pull bolt out of spreader plug - 3 -.

- Screw a 8 mm bolt (approximately. 80 mm long) into spreader plug - 3 -.

• When screwing the bolt into spreader plug, do not use excessive force on the plug otherwise it may fall inside into the door.

- Pull the spreader plug - 3 - out of the window guide - 1 - and out of door window.

- Remove the trim. Refer to => [ Trim ]






- Remove the door window - 1 - upward and at an angle - arrows - from the window shaft strip - 2 -.

Installing

• Spreader plug and spreader pin must always be replaced when performing assembly work on door window.

• Before inserting spreader plug - 3 - and spreader pin - 4 -, check window - 3 - for damage.






- Center the spreader plug - 3 - and insert spreader plug with window - 3 - removed.

- Press spreader pin - 4 - flush into spreader plug - 3 -.

- Install the door window - 1 - into the door - 2 - and insert the door window into the slot in the window regulator guide - 5 -.

- Using a light pressure from above - arrow a -, engage window - 1 - into window regulator - 5 -.

- Continue by performing the steps used in removal in reverse order.

• A function test must be performed before door trim is installed.