Engine Assembly - Fastener Tightening Specifications

Fastener Tightening Specifications






• 1 Always replace

• 2 Specification for the M23 collar bolt: 75 Nm

Engine Mount Bracket to Cylinder Block Bolt Tightening Sequence







Always use the correct tightening sequence and specifications for the engine mount bracket bolts. Otherwise tension could develop in the engine mount bracket and break it.

- First, tighten the new bolts by hand in sequence - 1 through 3 -.

- Then, tighten the new bolts in sequence to 40 Nm + an additional 180° (1/2) turn.