Outer Seal

Outer Seal

- Remove the front glass sunroof panel. Refer to => [ Glass Panel ] Glass Panel.

- Remove the rear glass sunroof panel. Refer to => [ Rear Glass Panel ] Rear Glass Panel.

- Remove the outer seal - 1 - in the adhesion area - 3 - from the roof - 2 -.






- Cut the profile of the outer seal - 1 - in the area - arrow - flush to the roof edge - 4 - all the way around.






- The remainder - 3 - stays between the roof - 4 - and the assembly frame - 2 -.

- Remove any adhesive residue with Adhesive Remover (VAS 6349).

- The adhesion surface on the roof cutout must be free of dust and grease.

- Clean adhesion surface thoroughly using Cleaning Solution (D 009 401 04).

- Wipe the adhesive surface on the roof cutout using the primer towel supplied.

- Always pay attention to the drying time for the primer towel supplied.

- Center the new outer seal - 1 - so that the joint - arrow - is at the center of the rear roof opening.






- Remove the protective film from the adhesive tape - 3 - on the new outer seal - 1 - and press the seal onto the roof - 3 -.

- Press the seal on evenly so that it does not stretch and become too long.

- Press the outer seal down using the roller (3356) two times evenly all around.

- Install the rear glass sunroof panel. Refer to => [ Rear Glass Panel ] Rear Glass Panel

- Install the front glass sunroof panel. Refer to => [ Glass Panel ] Glass Panel