Driver Interior Locking Button (E308)

Driver Interior Locking Button (E308)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• The push button illumination (L76) is integrated in the driver interior locking button and cannot be replaced separately.

Check the driver interior locking button (E308) (from MY 2010), refer to => [ Driver Interior Locking Button (E308) Checking, from MY 10 ] Testing and Inspection.


• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

Removal

The driver interior locking button (E308) can be checked before it is removed using the Vehicle diagnostic tester (from MY 2010), refer to => [ Driver Interior Locking Button (E308) Checking, from MY 10 ] Testing and Inspection.

- Remove the door trim panel.

- Disconnect the connector - 1 - and remove the screws - 2 -.






- Remove the door opener and driver interior locking button from the door trim panel.

- Release the tabs - arrows - and remove the driver interior locking button from the frame.






Installation

Install in reverse order of removal.