Instrument Panel Lamps and Switches

Footwell Lamps (W9)/(W10)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)

The Left Footwell Light (W9) / Right Footwell Light (W10) are removed and installed the same way so the procedure is only described for one of them.


• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

Removal

- Pry the left footwell lamp out of the trim panel under the instrument panel using (VAS 3409).






- Release and disconnect the harness connector - arrow -.






Replacing the Bulb

- Open the tabs - 1 - and remove the heat shield - 2 - from the lens on the left footwell lamp.






- Carefully pry the bulb out of the socket.






Bulbs: glass base bulb 12 V/5 W


• Do not touch the glass of the bulb, when installing. Fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

Installation

Install in reverse order of removal.