Headlamp Range Control Module (J431)

Headlamp Range Control Module (J431)


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the instrument panel cover on the front passenger side.

- Remove the bolt - arrow -.






- Remove the headlamp range control module (J431) - 1 -. Be careful of the different wire lengths still connected.

- Press the tab - arrow -, move the bracket - 1 - in - direction of arrow 2 - and disconnect the connector.






Installation

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specification. Refer to => [ HID Headlamps and Cornering Lamp Overview, from MY 10 ] HID Headlamps and Cornering Lamp Overview, from MY 10.

• It is necessary to code the headlamp range control module (J431). Refer to=> [ Headlamp Range Control Module, Coding ] Headlamp Range Control Module (J431), Coding and then perform a basic setting to the headlamp after installing a new headlamp range control module (J431).

- Check headlamp for functions.

- Check the headlamp adjustment and adjust again if necessary.