A/C Compressor Sub-Assembly Bracket, Engine Code BPY
A/C Compressor Sub-Assembly Bracket, Engine Code BPY
Special tools, testers and auxiliary items required
• Torque Wrench (V.A.G 1331/) (5 to 50 Nm)
• The bracket for A/C compressor and ancillary parts can be removed and installed without opening the refrigerant circuit.
• To remove the ribbed belt.
1 M10x45 Hex Collar Bolt
• Fitting hole
• 2.0L Turbo FSI engine: 40 Nm.
2 M10x45 hex collar bolt
• 2.0L Turbo FSI engine: 40 Nm.
3 M10x45 hex collar bolt
• 2.0L Turbo FSI engine: 40 Nm
4 M10x45 hex collar bolt
• 2.0L Turbo FSI engine: 40 Nm
5 A/C Compressor
• Removing and installing, refer to => [ A/C Compressor ] Service and Repair.
6 Hex Bolts M8×100
• 25 Nm
• Quantity: 3
7 M10x45 Hex Collar Bolt
• Fitting hole
• 2.0L Turbo FSI engine: 40 Nm
8 M10x45 Hex Collar Bolt
• 2.0L Turbo FSI engine: 40 Nm
9 Dowel Sleeves
• Quantity: 2
• Make sure they fit correctly between the auxiliary component bracket and the A/C compressor.
10 A/C Compressor Sub-Assembly Bracket
Number on the auxiliary component bracket (06F 903 143 E/F)
Removing
- Remove generator.
- Loosen A/C compressor, unscrew hex-bolts - 6 -. Remove A/C compressor from auxiliary component bracket and secure to body with appropriate material (e.g. welding wire), refer to.
- Remove the bolts - 1 - through - 4 - and - 7 - and - 8 - and the auxiliary component bracket - 10 - from the cylinder block.
Installing
• Always observe tightening torque of mounting bolts:
- Tighten hex collar bolt item - 1 - (fitting hole), - 7 - (fitting hole), - 4 -, - 8 -, - 3 - and - 2 - in succession.
Securing A/C compressor to body
If A/C compressor is removed and refrigerant circuit not opened, A/C compressor must be secure to body using appropriate material, a welding wire for example.
Ensure refrigerant hoses remain on A/C compressor without tension for this.
• When installing the belt ensure it is correctly seated in the ribbed belt pulley.
• Last, install ribbed belt over ribbed belt pulley of A/C compressor.