Solenoid Valve Wiring Harness (14 Pin Connector)

Solenoid Valve Wiring Harness (14 Pin Connector)

Removing

- Drain the Automatic Transmission Fluid (ATF). Refer to => [ Draining and Filling ] Testing and Inspection.

- Remove the valve body. Refer to => [ Valve Body ] Service and Repair.

- Disconnect the solenoid valve connector - 2 - from the transmission connector.






- Remove the bolt from the 14 pin transmission connector.

- Remove the connector with the wiring harness outward from the transmission housing.

Installing

Install in the reverse order of removal. Note the following:

- Replace the O-ring on the transmission connector.

- Coat the O-ring with ATF.

- Push the transmission connector all the way into the transmission.

- Tighten the bolt for the 14 pin transmission connector. For the correct tightening specification, refer to => [ Fastener Tightening Specifications ] Fastener Tightening Specifications.

- Install the valve body. Refer to => [ Valve Body ] Service and Repair.

- Fill the ATF and check the level. Refer to => [ ATF Level, Checking and Filling ] Testing and Inspection.