EVAP System Component Overview

EVAP System Component Overview






1 Fuel Tank

2 Vent Line

• Behind the right rear wheel housing liner.

3 Vent Line

• On the vehicle floor.

4 Vent Line

• To the EVAP canister purge regulator valve 1 (N80) at the intake manifold.

• To remove, press the release button.

5 Bolt

• 8 Nm

6 Evaporative Emission (EVAP) Canister

• for engine codes BGQ and CBUA.

• Installed location: On the bottom of the spare tire wheel well.

• Removing and installing, refer to => [ EVAP Canister ] Service and Repair.

7 EVAP Canister

• For engine codes BGP and CBTA.

• Installed location: On the bottom of the spare tire wheel well.

• Removing and installing, refer to => [ EVAP Canister ] Service and Repair.

8 Connecting Pipe

• Pressure side.

• On the vehicle floor.

9 Connecting Pipe

• Pressure side

• Behind the right rear wheel housing liner.

10 Bolt

• 3 Nm

11 Air Filter Housing

• For the leak detection pump.

12 Connecting Hose

• Intake side.

13 Bracket

• For the leak detection pump.

• Secured inside the right rear wheel housing.

14 Bolt

• 2 Nm

15 Nut

• 9 Nm

16 Leak Detection Pump (V144)

• Installed location: Under the right rear wheel housing liner.

• Removing and installing, refer to => [ Leak Detection Pump (V144) ] Service and Repair.

17 Connector

• Black, 3-pin

18 Vacuum Line

• Vehicles through MY 09: from the intake manifold.

• Vehicles from MY 10: from the connection to the vacuum line between the vacuum pump and the brake booster.