Entry

Entry

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• The part number for the radio is on a label on the radio housing.

• Deactivate the anti-theft protection when replacing the radio. Refer to => [ Electronic Anti-Theft
System, Deactivating ] Entry. Give the customer the new radio code.

• If the radio code is not known, you can retrieve it via the known systems. The radio serial number will be needed. It is on a label attached to the side of the radio. The serial number is also stamped in the side of the radio.

Removing


• Turn off the ignition and all electrical consumers.

• Remove the key.

- If there is a CD still in the radio, remove it. Refer to the Owner's Manual.

- Remove the upper cover and vents from the instrument panel. The screws under the center console should now be accessible.

- Remove screws - arrows -.






- Remove the center console cover using a (3409) - arrows -.






- Remove the screws - arrows - from the radio.






- Pull the radio out just far enough until the connectors on the back are accessible.

- Squeeze the connector lock in direction of - arrows -.






- Move the locking bracket in the direction of the - arrow - and remove the connector.






- Release the antenna connection - arrow - and remove the connector.






Installing

Install in reverse order of removal. Note the following:

• Never push directly on the display or the buttons when inserting the radio.

- Install the screws - arrows - in the radio.






- Anti-Theft Coding, Deactivating, refer to => [ Electronic Anti-Theft
System, Deactivating ] Entry.

- Check the radio coding. Recode again if necessary. Refer to => [ Entry Radio Components, Adapting ] Entry Radio Components, Adapting.

Torque specifications: 1.5 Nm