Roll Bar: Service and Repair

Wind Deflector

=> [ Wind Deflector Bearing ]

=> [ Rear Wind Deflector Bracket ]

=> [ Wind Deflector Locking Pin Assembly ]

Wind Deflector Bearing

Removing

- Switch ignition off.

- Remove seatbench.

- Remove backrest.

- Remove side trim.

- Remove bolts - 2 - (Qty. 2, 10 Nm) and remove wind deflector bearing - 1 - from side panel.





Installing

- Installation is performed in the reverse order of removal.

Rear Wind Deflector Bracket

Removing

- Remove wind deflector.





- Remove two bolts, respectively, and remove corresponding wind deflector bracket.

Installing

- Installation is performed in the reverse order of removal.

Wind Deflector Locking Pin Assembly

Removing

- Remove screws - 2 - (Qty. 4) on locking pin assembly - 1 -

Installing

Install new locking pin assembly - 1 - and screws - 2 - (Qty. 4).

Tightening specification: 1.5 Nm ± 0.2 Nm

• Do not reuse screws. Always use new screws that come with locking pin assembly kit.