Operating Lever

Hood

Operating Lever





1 Lower A-Pillar Trim Panel

2 Operating Lever

• Removing:

- Pull operating lever approx. 2 cm.

- Insert a small screwdriver into gap between operating lever and clip - 3 -.

- Release operating lever and unclip the clip from operating lever (clip falls behind trim).

• Installing:

- Engage clip - 3 - completely in operating lever.

- Press operating lever onto mount in mounting bracket.

- Check function before closing hood.

3 Clip

Hood Lock





1 Hood Lock

• Adjusting: within elongated holes

• Removing:

- Flip up clip - 6 -.

- Using a screwdriver - 5 -, press apart clevis arms of release lever - 3 - and remove lever.

- Remove bolts - 7 - and - 8 -.

- Unhook hood release cable - 9 -, disconnect harness connector for micro-switch (only vehicles with anti-theft warning system) - 10 -.

2 Connecting Plate

• Secured to lock carrier using pop rivets. Refer to=> [ Lock Carrier Assembly Overview ] Removal and Replacement

3 Release Lever

4 Clip

5 Screwdriver

As assisting tool

6 Clip

7 Bolt

• 5 Nm

• When reusing: Clean bolt thread using wire brush and nut thread using tap.

• Coat with locking fluid (D 185 400 A2)

8 Bolt

• 15 Nm

• When reusing: Clean bolt thread using wire brush and nut thread using tap.

• Coat with locking fluid (D 185 400 A2)

9 Hood Release Cable

10 Micro-switch