Two Pieces Right Backrest Lock

Rear Seats

Two Pieces Right Backrest Lock

Removal

- Remove backrest. Refer to => [ Two Piece Backrest ]. Two Piece Backrest

- Remove cushion. Refer to => [ One Piece or Right-Hand Side Backrest Cover and Cushion Assembly Overview ] Rear Cover and Cushion (Overviews).

- Press connecting rod ball joint - 1 - off catch - 2 - using screwdriver - arrow -.





- Remove circlip - 1 - from pin - 2 -.





- Remove spring - 3 - from backrest - 4 - using a screwdriver.

- Remove pin - 2 - from backrest - 4 -, hold spring - 3 - in place using pliers and remove while doing this.





- Disengage button housing - 1 - - arrow - and remove from rear panel - 3 -.





- Remove release rods - 2 - and clips - 4 - from rear panel - 3 -.

• Clips - 4 - can be removed from rear panel when spreader pins are pressed out of clips. (Remove spreader pins from rear panel for reinstallation.)

Installation

To install, perform the steps used in removal in reverse order.

- Pin - 2 -, spring - 3 - and catch - 5 - must be inserted together.





- Engage circlip - 1 - on pin - 2 -.

- Tension spring - 3 -.

- Perform functional check when completely installed, readjust catch if necessary.

Adjusting catches

- If present, loosen nut - 3 - and press connecting rod ball joint - 1 - off catch - 2 - - arrow - using screwdriver.





- Turn ball joint - 1 - on operating rod so that effective length of connecting rod becomes larger or smaller.