Sunroof Assembly Overview

Sunroof Assembly Overview






1 Panorama sunroof glass panel (one-piece safety glass)

• Removing the glass panel for the panorama sunroof

• Installing the glass panel for the panorama sunroof

• Adjusting the glass panel for the panorama sunroof

2 Hinge

• Quantity: 2

• Removing and Installing, refer to => [ Swiveling Bearing ] Swiveling Bearing

3 Sliding block

• Quantity: 2

• Removing and Installing, refer to => [ Control Cables ] Control Cables

4 Guide rail

• Quantity: 2

• Removing and Installing, refer to => [ Control Cables ] Control Cables

5 Bolt

• Screws are microencapsulated and must always be replaced after removing.

• Quantity: 1

• Tightening specification: 2 Nm.

6 Slotted guide rail

• Quantity: 2

• Removing and Installing, refer to => [ Slotted Guide Rail ] Slotted Guide Rail

7 Cable

• Quantity: 2

• Removing and Installing, refer to => [ Control Cables ] Control Cables

8 Hinge mount

• Quantity: 2

• Removing and Installing, refer to => [ Swiveling Bearing ] Swiveling Bearing

9 Bolt

• Screws are microencapsulated and must always be replaced after removing.

• 2 on each side

• Tightening specification: 1.8 Nm.

10 Assembly frame

• Removing and installing the assembly frame => [ Assembly Unit ] Assembly Unit

• if necessary use special grease G 000 450 02 exclusively to grease guide channels, otherwise the functions cannot be guaranteed.

11 Bolt

• Screws are microencapsulated and must always be replaced after removing.

• Quantity: 1

• Tightening specification: 2 Nm

12 Bracket

13 Protective tubes

• For the control cables.

14 Bolt

• For the cover plate.

15 Bolt

• Screws are microencapsulated and must always be replaced after removing.

• Quantity: 3

• Tightening specification: 3.5 Nm

16 Clip

17 Electrical drive motor

• Removing, refer to => [ Panorama Sunroof Glass Panel Drive ] Panorama Sunroof Glass Panel Drive

• Drive Motor, Neutral Position, Adjusting, refer to => [ Sunroof Motor, Adjusting Neutral Position ] Sunroof Motor, Adjusting Neutral Position

• The hex wrench in the previously known shape is not supplied in the vehicle. Use a commercially available size 4 hex wrench.

18 Cover plate

19 Clip