Converter with Socket, 12 V-115 V U27

Converter with Socket, 12 V-115 V U27

Special tools, testers and auxiliary items required

• Removal Wedge (3409)

• The Converter with Socket, 12V, 115V housing contains chargeable capacitors.

• There is a danger of electric shock.

• The housing of Converter with Socket, must not be opened under any circumstances.

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( (3409) , screwdriver) will be positioned, using commercially available adhesive tape.

• No repairs may be performed on the harness connector, on the wires and the 115V-outlet.

• If there is a fault at harness connector, at wires, at 115V-socket or in the converter, the complete unit must always be replaced.

Removing

- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

- Carefully remove trim - 1 -.






- Remove screws - arrows -.






- First pull panel toward rear in - direction of arrow 1 -, then upward in - direction of arrow 2 - and remove panel.






- Disengage harness connector - 1 - and disconnect harness connector.






- On vehicles with heated rear seats, unclip rear heated seat regulating switch from panel.

- Disengage power outlet at retaining lugs - arrows - and disconnect it.






- Remove screws - arrows -.






Installing

Install in reverse order of removal.